οδηγίες χρήσης CHICCO CHICCO GO

[. . . ] 7 Switching on and off / Selecting the operating mode . 8 Adjusting the carrying handle and the stand . Notes on the Declaration of Conformity . 11 12 12 13 13 CHICCO GO 1 GB IE CY Introduction Information for these operating instructions These operating instructions are a component of the Cordless Handheld Spotlight CHICCO GO (henceforth designated as the appliance) and they supply you with important information for the intended use, safety and connection as well as operation of the appliance. [. . . ] The power adapter and the car adapter may not be used outdoors, only in indoor dry rooms. The car adapter may only be connected to the car cigarette lighter or an on-board power outlet supplying 12 V. Always first connect the Cordless Handheld Spotlight to the power adapter or the car adapter, then connect the power adapter/car adapter into the power supply. 4 CHICCO GO In the event of damage to the power adapter/car adapter, in order to avoid hazards arrange for it/them to be exchanged by authorised personnel or the Customer Service Department. NEVER use the AC adapter/car adapter with a damaged power cable. There will be the risk of a fatal electrical shock. NEVER cover up the reflector during operation. Maintain a sufficient distance from the illuminated area (at least 0. 5 m), otherwise there is a risk of fire from the generated heat. A broken protective disc must be replaced before further use. There is a risk of personal injury. GB IE CY NEVER operate the appliance without its protective disc. Setting up and connecting to the power supply Items supplied and transport inspection The appliance is delivered with the following components as standard: Cordless Handheld Spotlight Mains power adapter 12 V car adapter Carrying strap These operating instructions NOTICE Check the contents to ensure that they are complete and for signs of visible damage. If the delivery is not complete or is damaged due to defective packaging or through transportation, contact the Service Hotline (see chapter Service). Unpacking Remove all components of the appliance and these operating instructions from the carton. Place the On/Off switch 6 at the position "I" to switch the LED ambient lighting on. Place the On/Off switch 6 at the position "II" to switch the LED flashing light on. Place the On/Off switch 6 at the position "0", to switch the LED ambient lighting resp. Place the On/Off switch 7 at the position "I" to switch the halogen spotlight on. Place the On/Off switch 7 at the position "II", to switch the LED spotlight on. Place the On/Off switch 7 at the position "0", to switch the halogen resp. LED spotlight off. Adjusting the carrying handle and the stand You have the possibility to adjust the carrying handle 4 into the pistol position or into the lantern position. To do this, press the button 3 on the handle 4 and at the same time turn the handle 4 into the upper or lower position until it engages. The pistol position is used to illuminate distant objects; the lantern position is well suited for area searching. Clean the housing of the appliance only with a lightly moistened cloth and a mild detergent. Disposal Disposal of the appliance Do NOT dispose of the appliance in your normal domestic waste. This product is subject to the provisions of European Directive 2002/96/EC (Waste Electrical and Electronic Equipment). [. . . ] The appliance is intended solely for private, not commercial, use. If this product has been subjected to improper or inappropriate handling, abuse, or modifications not carried out by one of our authorised sales and service outlets, the warranty will be considered void. Your statutory rights are not restricted in any way by this warranty. The warranty period is not extended by repairs effected under warranty. [. . . ]