οδηγίες χρήσης SIEMENS GIGASET AS140

[. . . ] EN Dear Customer, Gigaset Communications GmbH is the legal successor to Siemens Home and Office Communication Devices GmbH & Co. KG (SHC), which in turn continued the Gigaset business of Siemens AG. Any statements made by Siemens AG or SHC that are found in the user guides should therefore be understood as statements of Gigaset Communications GmbH. Sehr geehrte Kundin, sehr geehrter Kunde, die Gigaset Communications GmbH ist Rechtsnachfolgerin der Siemens Home and Office Communication Devices GmbH & Co. [. . . ] (page 7) All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities. This crossed-out wheeled bin symbol on the product means the product is covered by the European Directive 2002/96/EC. The correct disposal and separate collection of your old appliance will help prevent potential negative consequences for the environment and human health. It is a precondition for reuse and recycling of used electrical and electronic equipment. For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service or the shop where you purchased the product. 2 Do not pollute the environment. Emergency numbers cannot be dialled if the keypad lock (page 3) is activated!Not all of the functions described in this manual are available in all countries. Closing the battery cover Place the cover on the battery compartment as shown in the diagram, then push it up until it snaps into position. Setting up the telephone for use Step 1: Connecting the base 1 2 Opening the battery cover Press down on the battery cover below its upper end and slide the cover down. Connect the phone jack with the phone cord 1 and the mains units (230 V) with the power cord 2 as shown. The two cords must be plugged in at all times. Use only the mains unit supplied (see the bottom of the base). If you ever purchase another phone cord from a store, ensure that the phone conductors are correctly connected: 3-4 connection of the telephone conductors/EURO CTR37. W Step 2: Setting up the handset Fitting the battery pack Fit the plug into the socket. Insert the battery (see diagram below). Place the battery leads in the cable guides. Place the battery leads in the cable guides so that the battery cover cannot catch on the leads and damage them when it is closed. Only insert the recommended rechargeable battery pack, i. e. never use a normal battery pack as this could damage your health and cause injury. Never use non-Siemens battery chargers as this could damage the battery pack. Only place the handset in the base/ charging cradle that is intended for it. Step 3: Registering the handset to the base and charging the battery pack Place your handset in the base with the display facing forwards. The handset will now register automatically to the base. For procedure see page 4. Charging the battery pack To charge the battery pack, leave the handset in the base for approx. The charge status of the battery pack is correctly displayed only after uninterrupted charging/discharging. You should not therefore interrupt the charging process. Charging is electronically controlled to prevent overcharging. The battery pack heats up during charging; this is normal and not dangerous. [. . . ] The Guarantee is issued by Siemens Home and Office Communication Devices GmbH & Co. KG, Schlavenhorst 66, D-46395 Bocholt, Germany. Any claims that differ from or extend beyond these mentioned in this manufacturer's warranty shall be excluded, except from cases expressly specified in the applicable law. (In no event shall Siemens be liable for any loss of business, profits or data, additional software loaded by the customer or other information. [. . . ]