οδηγίες χρήσης SILVERCREST SED 3.7 A1

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. , . EPILATOR SED 3. 7 A1 KOMPERNASS GMBH Burgstraße 21 D-44867 Bochum www. kompernass. com EPILATOR Operation and Safety Notes GB / IE / CY GR / CY Operation and Safety Notes Page 1 17 Last Information Update· : 01 / 2012 · Ident. -No. : SED3. 7A1112011-3 IAN 71087 IAN 71087 1 2 3 3 4 5 6 7 8 0 9 q Table of Contents Introduction . 2 Information about these operating instructions . 16 GB IE CY SED 3. 7 A1 1 GB IE CY Introduction Information about these operating instructions These operating instructions are a component of the Epilator SED 3. 7 A1 (hereafter designated as the appliance) and they provide you with important information about the intended use, safety, connection and operation of the appliance. [. . . ] Shorter hairs are not gripped by the tweezers and plucking out longer hairs is very painful. The skin must be free of grease or cream residues. Otherwise, the tweezers will stick/soil and the efficiency of the appliance will be reduced. The best time for epilation is in the evening after a shower. Then the skin is somewhat softened, so that the hairs can be plucked out easily. In addition, the skin can recover overnight, and any skin reddening will recede. Before epilation, treat the skin with a peeling or a massage glove. This helps remove dead skin cells, ingrowing hairs are avoided, and fine hairs stand proud. This enables the appliance to grip the hairs better. After epilation, nurture the skin with a moisturising lotion or cream. Ideally, the cream will contain aloe vera or camomile extracts to soothe and maintain the skin. GB IE CY Epilation When the appliance is charged and the body part to be epilated is prepared: 1) Rub your hand once more against the growth direction of the hairs to be removed. Through this the hairs will be raised so that they can be better captured by the tweezers. 2) Remove the protective cap 1 from the epilator head 2. SED 3. 7 A1 9 GB IE CY 3) Press the travel lock 5 and slide the speed switch 6 upwards to the desired speed level: Level 1: for sensitive areas (armpits and bikini line) Level 2: for legs 4) Hold the skin tight with one hand. 5) Place the epilator perpendicular to the skin and, without exerting any pressure, move it against the direction of the hair growth. Thereby, the side with the speed regulator 6 must face towards you. Do not make back and forth or circular movements. Always start anew and pass over the body part to be epilated several times, so that all of the hair is removed. NOTICE It may be that the hair grows back after a few days. The reason for this is that these hairs were too short to be removed during the last epilation session. 6) When you are finished with the treatment, place the speed switch 6 to "0". [. . . ] Damages and defects extant at the time of purchase must be reported immediately after unpacking, resp. no later than two days after the date of purchase. Repairs carried out after lapse of the warranty period are subject to charge. GB IE CY Service Great Britain Tel. : 0871 5000 720 (£ 0. 10/Min. ) E-Mail: kompernass@lidl. co. uk IAN 71087 Service Ireland Tel. : 1890 930 034 (0, 08 EUR/Min. , (peak)) (0, 06 EUR/Min. , (off peak)) E-Mail: kompernass@lidl. ie IAN 71087 CY Service Cyprus Tel. : 8009 4409 E-Mail: kompernass@lidl. com. cy IAN 71087 SED 3. 7 A1 15 GB IE CY Importer KOMPERNASS GMBH BURGSTRASSE 21 44867 BOCHUM, GERMANY www. kompernass. com 16 SED 3. 7 A1 . 31 GR CY SED 3. 7 A1 17 GR CY SED 3. 7 A1 ( ) , , . [. . . ]