οδηγίες χρήσης SILVERCREST STGR 1600 A2

[. . . ] · The appliance must be supplied through a residual current device (RCD) with a rated tripping current not exceeding 30mA. · The appliance must be plugged into a mains power socket fitted with a protective conductor. To avoid the risks of fire or injuries: · Never leave the appliance unsupervised during use. · Do not place the appliance under cupboards or close to curtains and other easily inflammable materials and also keep such combustible materials away from the appliance. · This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. [. . . ] Insert the three tenons of the splatter protection shield w into the holes provided on one side of the grill bars q. To do this, the splatter protection shield w must be lightly flexed. · Place the grill bars q on the catchment pan r, such that they are firmly seated. The 4 mounting pegs on the top plate of the stand must encroach into the depressions on the underside of the grill. The grill must sit firmly on the stand. Notice You can also use the grill without the stand: Place the grill on an absolutely level and even surface. The surface must be insensitive to heat. Otherwise, it could cause damage to the surface. · Check to ensure that the grill bars q are correctly placed onto the catchment pan r (see Fig. · Insert the power cable with thermostat i into the appliance such that the control lamp u is facing upwards. Then insert the plug into a mains power socket. · Adjust the thermostat i to the desired temperature setting. The grill starts to warm up and the indicator lamp u glows. · As soon as the indicator lamp u goes out the grill has reached the adjusted temperature and is ready for use. Handling the grill A good and even heat distribution is assured by the integrated heating element y under the grill q. Cleaning is made easier by the non-stick coating, which prevents the adhesion of grillables. · Place the assembled stand on a level surface. Bear in mind that there needs to be a mains power socket in the close vicinity. -4- Notice Subject to the ambient temperature, it can happen that the control lamp u does not go out with the thermostat setting "M". · After a warm-up phase of approx. 15 minutes the grill is ready for use. Notice The times given may vary, depending on the composition of the grillables and personal taste! Cleaning and care Attention! Before starting to clean it, remove the plug from the power source and the thermostat i from the appliance. Allow the appliance to cool down completely before cleaning it!Risk of Burns! Risk of injuries When the grill has warmed up, take hold of it ONLY with the heat-insulated handles t. Thermostat adjustments Level 0 Level 0 - 1 Level 1 - 3 Grill switched off Grill switched on; low temperature Grill switched on; medium temperature (e. g. vegetables) Level 3 - M (Max) switched on; high temperature (e. g. meats) Attention! Take steps to ensure that neither the power cable nor the plug come into contact with water or other fluids. [. . . ] Your statutory rights are not restricted in any way by this warranty. The warranty period will not be extended by repairs made under warranty. This applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. [. . . ]