οδηγίες χρήσης TNB DARK BOOSTER

[. . . ] This documentation is copyright protected. every copying, also as extracts, as well as any reproduction of images, even in an altered state, is only permitted with the written consent of the manufacturer. Intended use This appliance is intended for receiving generally approved radio transmissions in all countries (world receiver) and only for domestic use. Utilisation other than as described here is not permitted and it could lead to damages and injuries. No liability will be accepted for damages resulting from misuse or improper handling, the application of force or unauthorised modifications. Technical Data This appliance fulfills, in regard to conformity with, the fundamental requirements and other relevant provisions of the EMC Directive 2004/108/EC, the Low Voltage Directive 2006/95/EC and the Ecodesign Directive 2009/125/EC (Commission Regulation 1275/2008 Annex II, No . 1). -2- Power consumption: Power consumption Standby: Operating temperature: Humidity: Dimensions (W x H x D): Appliance weight: Power transformer weight: 5 watts approx. [. . . ] To switch off press the VOL. +/AL­1 (or VOL. ­/AL­2) button. · Note: Please take note that the last tuned radio station together with the last used sound volume setting is used for the alarm call. Interrupting the alarm · Press the button SNOOZE to interrupt the alarm for 10 minutes (default setting) (see also the section "Setting the snooze function"). - 21 - Set snooze time · · With the radio switched off, press the button MODE seven times. The screen displays the snooze time set (default is"SNO 10"). Use theUP and DOWN buttons to set the snooze time to a time between 1 and 59 minutes. Turning off the alarm function · Press the VOL. +/AL­1 or VOL. ­/AL­2 button until the relevant alarm symbols disappear from the screen. Stop watch function The stop watch function is only available when the radio is switched off. · Press and hold down the PAGE button for around 2 seconds, the screen shows 0. 00 0 U. · Press SNOOZE to start the stop watch. The maximum time for the stop watch is 39 minutes and 59 seconds. If the stopwatch exceeds the maximum time, the indicator 39:59. 0 appears and flashes in the display. · During time measurement, it can be stopped by pressing SNOOZE. · Pressing SNOOZE again restarts the stop watch. · Hold down SNOOZE to reset the stop watch. · Leave the stop watch by pressing PAGE. Countdown function The countdown function is only available when the radio is switched off. Set and save countdown · Press and hold down the MEMORY SCAN button for around 2 seconds, the screen shows 0. 00 D. · The UP and DOWN buttons can now be used to set the desired frequency. · If you keep UP or DOWN pressed for about three seconds, the automatic station search will start. · The search stops as soon as a station with sufficient signal strength is found. · Setting the MW band Since the radio transmitter systems differ from one country to another, you should make the appropriate setting via the reception range setting: · With the radio switched off, press the button MODE six times and then select, using the buttons UP resp. DOWN, the appropriate reception range as per the following table: - 25 - Region Channel spacing Amerika 10 kHz Europa 9 kHz Band range 520-1710 kHz 522-1656 kHz Fine tuning If a station can not be found precisely the fine tuning can be use to improve reception. · During the channel search press the FINE button, the screen shows FINE. · Now, using the buttons UP resp. DOWN, adjust the required reception range with smaller frequency steps. · By pressing the FINE again you leave the fine tuning function again. This function is not available for the LW frequency range. Aerial The rotatable telescopic aerial on the radio can be used for the FM and SW bands. · Pull the aerial out fully and arrange it for optimum reception. [. . . ] VOL. -/AL­2 . . · PAGE . - 54 - . · MEMORY SCAN . - 5 : M. 0/5 5:00 M. 1/6 10:00 M. 2/7 15:00 M. 3/8 20:00 M. 4/9 25:00 · MEM, , MEM. M. 0/5 - M. 4/9 , - . [. . . ]